Fadal spindle controller or driver fault

Download Driver Here --> https://tinyurl.com/2p95aeav (Copy and Paste Link)

Fadal Maintenance Manual ATC Failure Check to see if the Z axis alignment was properly set at cold start. The automatic tool changer has failed to respond to an M6 or the TC,1 command. Try a power off and power on. If this does not help check the fuses. The fuses F5, F6, F7, and F8 should be checked to see if they are burned out. fadal maintenance manual figure error codes (continued) occurs during spindle operation if both encoder feedback and spindle magnet are not detected for longer than 3 seconds no yes #10 encoder and magnet not responding or spindle not turning is spindle turning? go to chart 3 spindle driver check spindle encoder and magnet and their cabling #  · An overview of the Fadal Spindle Drive system and checks to perform upon failure. Always check the basics before replacing parts Common Failure Points Recommended To Check 1) Parameter Settings - The HIGH TORQUE/RIGID TAP parameter: For machines with Wye/Delta wiring, verify the parameter is set to HIGH TORQUE/RIGID TAP.

It is common for the B-axis to have ABP30N for positive travel and 30 negative travel limits. Also notice the version number AC, the -5 indicates for use with the axis controller, this Eprom can also be used with the axis controller. Spindle EPROMs. The Spindle control card uses a special version of software. Section Three: Spindle Drive and Motors Mar Fadal If a problem is detected (Output fault) check the spindle motor leads with an Ohm meter by disconnecting the output leads at T1, T2 and T3. Check the leads going to the motor side leg to leg. Resistance readings between the three combinations of legs should each read between to.8 ohms. the spindle controller card in slot #14 to the spindle inverter. The inverter does exactly what it’s told to do, which is why an Inverter Battery Box (SVT) is key in troubleshooting inverter problems. With a battery box (seen here), you can bypass the control and run the drive directly from the battery box. If it doesn’t work.

It looks like a big, heavy machine so 4KW or so spindle motor? keyboard, etc in the control panel, Plus the Fadal VH65 4th axis with. 18 Nov, This drive was completely rebuilt from top to bottom and the major failures were problems in the power supply stage and a open power igbt. After. Have you run into issues with your mill spindle? Like overheating, stuck tools, or noise and vibration? Often it isn't actually the spindle that's at fault.